1. To create bright and attractive earrings, buttercups, we need: polymer clay of three colors, baked glue or gel of a transparent color, a base for earrings with an English lock and a platform for cabochon, rubber surgical gloves, a blade. Note: in my opinion The clay Cernite is perfect for this job. It softens quite easily, but a very thin petal can be formed from it, and also it is very strong and light.2 . From a piece of plastic acid-yellow, pre-wearing gloves, we form a drop, rolling plastic between the index finger and thumb. Depending on the size of the future flower, the size of the “drop” may vary.3. We make 2 blanks. Note: gloves will make the work more accurate.There will be no fingerprints on the petals, and dust and dirt will not be deposited by hands.4. We take acid-coral plastic and form small balls (2-4 mm in diameter), such circles need to be made from such a calculation that the petals of this color will be arranged in 2 rows - in the first there will be 3 petals, and in the second - 5. Those. just need to roll 16 balls.5. Each ball must be stretched between the index finger and thumb and turned into a petal.6. Next, we begin to overlap the coral petals on the narrow part of the billet. Attach the first.7. It is visually easy to see how the second petal is attached.8. We fasten the third petal in the same way - overlapping the previous one.9.In the same spirit, we continue to fasten the remaining petals, tightly pressing them to the base.10. The next step is the manufacture of rose petals. They should be about 22-24, i.e. 11-12 for each flower. Fasten the petals in 2 rows and get the finished flower. Note: It is better to attach the petals of different size. In the first rows - smaller, in the last - larger ones.11. Now it is necessary to cut off the tail that has come from the base of the drop and the petals. To do this, we stretch our fingers with our fingers and push off the plastic that is at the very base of the flower.12. Next, cut off the blade "tail", while the cut-off area should be approximately equal to the cabochon mounting area based on the earring.13. We take glue for baking and lubricate the inner surface of the platform of the earring base. Note: glue or gel of a transparent color will help the flower to fix well on the platform.The most widely used for this purpose is the transparent liquid Fimo gel and the thermal glue Scalpi.14. Immerse the cut bud on the base and send to bake for 25 minutes at a temperature of 120 degrees (depending on the type of polymer clay used).
What you need for tanning
How to unlock htc
How to bake potatoes in the microwave
How to zip up jacket
What dreams of birch, dream book