• How to change outlets yourself?

    ​​Sometimes it happens so that the outlet fails and needs to be replaced. To do this, it is not necessary to contact a specialist, because you can replace the outlet yourself.

    ​​Not worth forget that there are people whose fear of electricity will not allow them to change the outlet themselves. In this case, of course, only a specialist will help.

    ​​For to replace an outlet without a specialist you should have pliers, screwdrivers, a voltage indicator, a knife.

    In the process of work, you need to understand the differences between our and euro sockets, since there are some nuances when installing them.When replacing sockets, it is important to remember the most important rule: compliance with safety regulations when working with high voltage. Be sure to turn off the power supply to the outlet, as non-observance of this rule may have negative consequences.

    ​​Current in the outlet you need to disconnect the plugs or automatic, the location either in the apartment panel or in the stairwell. In order to make sure that there is no electricity in the outlet, a voltage indicator will be required. As soon as the indicator has shown that there is no current, and nothing interferes with the work, you can proceed.

    ​​proceed to remove the socket from the opening in the wall. To do this, use a screwdriver to unscrew the screw that secures the outlet to the wall. Then the outlet must be carefully removed. In order to completely remove the socket from the wall, it is necessary to loosen the spacer plates by slightly unscrewing the fixing bolts that are located on both sides of the socket. Only then the outlet can freely exit its socket. And now it is necessary to unscrew the screws on the terminals that hold the wires that supply current.After all these procedures, you can completely remove the outlet.

    ​​Before installing A new outlet must first lead electrical wires into the terminals. Now the main thing - careful fixing of wires. In the case where three wires are used for the installation of an electrical network, the third one must necessarily be grounded. As a rule, all wires differ in colors: the phases are brown, black, empty are blue, and the ground wire is green or yellow.

    ​​wires will all be attached, they need to be very carefully, so as not to break, drown in a box, and then insert the outlet itself. Plates of thrust are not immediately fixed. This is done only when the socket is well installed. After this, the spacer plates should be fixed. And with the screws at last, you need to secure the socket firmly to the box. If the outlet is well fixed, then it will no longer fall out.

    ​​The most recent the step will befixing the outlet cover. Now you can turn on the electricity. These simple actions will not take much time.

    But if there is damage or a burnt wire in the flat panel, you must call specialist and, in any case, do not climb yourself.


    Related news


    Hot Cakes - Australian Ricotta Pancakes
    Paraffin, cosmetic procedures
    What to wear with pants
    What is OBZH
    What is pharyngitis
    The laws of dialectics
    Why do people break up
    How to cancel sending SMS