• How to run a gas station

    You will need
    • - ink for refilling;
    • - three syringes of 10 ml.
    Instruction
    Cartridges of inkjet printers of different models may differ, but the general technology of refueling is the same. You will need the ink of the right colors, usually red, yellow, and blue (some printers additionally have black refilled). They can immediately be sold in syringes, tubes of 20 ml, or you will need three ordinary medical syringes of 10 ml, in which you should collect ink of the desired colors.
    Remove the cartridge from the printer following the instructions for use. The amount of ink is definitely poured into the cartridge, the necessary volume is usually indicated on the body. Put the cartridge on the newspaper with the printheads down, then drill in each of the three compartments, pierce it, burn it with a heated needle through the hole. It should be located at the top of the cartridge, sometimes it already has a specially designed place.
    Carefully insert the needle of the syringe with the ink of the desired color into the hole and refill the cartridge, usually about 6 ml is poured.Similarly, refill the other compartments with ink of the corresponding colors. Let the cartridge stand for about five minutes, then tape the filling holes with tape. Reinsert the cartridge into the printer and run several cleaning cycles, usually from 1 to 3. Check for print quality � if it is bad, repeat the cleaning cycle. After that, the printer should start working normally.
    Since self-refilling cartridges by users is unprofitable for printer manufacturers, they began supplying cartridges with special chips that control ink consumption. When the ink runs out (or the chip decides that they run out), you will have to buy a new cartridge. However, users in this case found loopholes. In the simplest case, just buy a new chip and put it on the refilled cartridge. Buying a chip and paint for refueling is cheaper than buying a new cartridge.
    On some models of printers, users have learned to reset the chips, which allows the use of cartridges almost an unlimited number of times. Finally, many users began installing self-made CISS on an inkjet printer - continuous ink supply systems, this method should be considered the most successful solution to the problem.In such a system, the ink compartments in the cartridge are connected by thin tubes with donor containers, from which the ink enters the cartridge as they are consumed. Thus, the cartridge is never empty.

    Related news


    What dreams lie
    Does it hurt to burn erosion
    How to apply celandine acne on the face
    What to ride in the train
    Beadwork with your hands: a butterfly
    How to become the perfect girl football fan: instructions
    When to plant strawberries