• Tool for unscrewing caps on cans

    Materials, tools

    For our miracle invention, we will need:
    • A small section of a wooden block with a cross section of 20x30 mm;
    • Used PET canister for 3 or 5 L
    • A wooden stick from ice cream;
    • A few screws with a wide hat on wood (press-washer).
    There are very few tools you need to work with - a hacksaw, a paint knife , screwdriver, pencil and scissors. And do not forget about the most important tool in the workshop - a hammer! (where to go without it).
    Device for loosening the lids on the cans

    Getting tinkering

    The main element of our bottle opener is a wooden bar. He will work with him from the very beginning. For ease of processing, the author used a vice, as shown in the photo.
    Device for loosening the lids on the banks
    We clamp the bar in a vice and cut off a fragment of 10-12 cm for the handle.For a cleaner cut, it is advisable to do it with a hacksaw for metal with a small tooth tooth.
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for loosening the covers on the banks
    Next, one end of the finished handle is cut at an angle of 35-45 degrees. We clean the end with a small file or file.
    Device for loosening caps on banks
    Device for loosening caps on banks
    The device for loosening the lids on cans
    This should happen exactly like this.
    Device for loosening caps on banks
    From the side of the trimmed plane, mark the perpendicular line. We use a superfile as a ruler, and a marker for markup.
    The device for unscrewing the lids on the banks
    We make the incision with a hacksawuntil the middle of the bar. If the groove is too narrow. It is necessary to flare it with the same blade or a knife, and modify it with fine-grained sandpaper.
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for unscrewing the lids on the cans
    Cut a strip of width equal to our bar from a plastic canister. You can do this work as accurately as possible with a knife.
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for loosening caps on banks
    Tool for unscrewing the caps on the cans
    It was the turn to use a secret weapon - a stick of ice cream))
    Device for loosening the lids on the banks
    With her we wedge the plastic tape inserted into the slot made by the hacksaw. We knock it lightly with a hammer for reliability, trying not to split the bar. Sticking out the remains of a wooden stick is cut off with scissors on both sides.
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for loosening caps on banks
    Device for unscrewing the lids on the banks
    You can fasten the tape on two screws. To do this, it is imperative to make preliminary holes at the place of their screwing in. This can be done with a 3mm drill and a screwdriver.
    Tool for unscrewing the caps on the cans
    Device for loosening the lids on the banks
    We twist the screws and get a ready-made advanced invention useful in the economy. Now is the time to try it out. Cover the lid with a twist-off hinge, and turn to the side of the cut bar. And, lo and behold! Bank opens almost without effort.

    Related news


    Brother and sister are not friends: common mistakes of parents
    Tip 2: What is gastritis and how to treat it
    Bouquet
    How to cook lean okroshka
    Painting on glass - imitation of stained glass
    Fresh juices: good or bad
    How to make a simple hairstyle
    Refrigerator repair